Blog
Maintenance method of high precision chuck
The high-precision chuck should be disassembled and cleaned at least every 6 months to keep the sliding surfaces of the jaws clean and lubricated to prolong the life of the chuck.
Release time:
2022-04-22
The high-precision chuck should be disassembled and cleaned at least every 6 months to keep the sliding surfaces of the jaws clean and lubricated to prolong the life of the chuck. However, if the cutting cast iron is thoroughly cleaned at least once or several times every 2 months, check the parts for cracks and wear, and replace them with new ones immediately. After the inspection is completed, it must be fully oiled before it can be assembled.
For different workpieces, you must use different clamping methods or choose to make special fixtures. Reluctantly using it to clamp irregular or strange workpieces will cause damage to the chuck! If the chuck pressure is abnormal, the chuck will be under high pressure, or After the machine is turned off, the chuck will also clamp the workpiece, which will reduce the service life of the chuck! So when you find that the gap between the chucks is too large, you must replace the new chuck immediately.
Using cutting oil with anti-rust effect can prevent rust inside the high-precision chuck, because rust on the high-precision chuck will reduce the clamping force and make it impossible to clamp the workpiece.
Wholesale,high,precision,chuck,Low,price,high,precision,chuck,high,precision,chuck,Wholesale,Price,high,precision,chuck,manufacturers
Previous Page
Latest information
2023-03-09
2023-02-28
Contact Us
Tel: +86-519-83208876
Tel: +86-13861278968
Email: carrieshi@terektool.com
Email: monicaduan7@hotmail.com
Address: No.138,wangxia village,luoxi town,xinbei area,changzhou city, jiangsu province,China
Submit your request online
