Blog
How to reduce wear on turning inserts
First, the turning test was carried out with the cutting amount as the changing condition, and the cutting force and cutting temperature were studied; then the thermodynamic characteristics of the turning insert were studied.
Release time:
2022-08-16
First, the turning test was carried out with the cutting amount as the changing condition, and the cutting force and cutting temperature were studied; then the thermodynamic characteristics of the turning insert were studied. On this basis, the influence of the turning insert wear on the cutting force and heat was analyzed. Turning comparison test under cooling conditions, to analyze the influence of the use of cooling conditions on the cutting process of titanium alloys.
Secondly, on the basis of tribology, the chip contact characteristics of the rake face are studied. By analyzing the metal cutting process, the chip flow form in the bonding area and the sliding area of the chip contact surface is studied. And according to the chip contact The characteristics of the bonding zone and the sliding zone are analyzed, and the hybrid model of the friction coefficient of the sliding zone is established by combining the analytical model and the simulation test.
corner,radius,cutting,tool,manufacturers,Wholesale,corner,radius,cutting,tool
Previous Page
Next Page
Previous Page
Next Page
Latest information
2023-03-09
2023-02-28
Contact Us
Tel: +86-519-83208876
Tel: +86-13861278968
Email: carrieshi@terektool.com
Email: monicaduan7@hotmail.com
Address: No.138,wangxia village,luoxi town,xinbei area,changzhou city, jiangsu province,China
Submit your request online
